Installation manual BMW X6 F16 Carbon Fiber M-Performance bodykit

Installation manual for Bodykit – BMW F16 Carbon Fiber M-Performance bodykit

Bodykit can be found here

For installation you will need:

1) Hands

2) Adhesive/glue and a gun

3) Metallic rivets and a gun for it ( or screws )

4) Paper scotch tape

5) Electronic drill to drill correct holes for rivets

Front lip installation process

Required : 2) 3) 4) 5)

Do a test fit to find out how the lip must be installed to a front bumper. Please use brackets ( supplied with carbon fiber bodykit ONLY ) – you need to drill holes and fasten brackets to the lower part of the front bumper. Brackets are required to hold the front lip. Lower lip must be attached/fastened to a lower part of the bumper using existing bolts

 SAM_2588          Apply adhesive to a bracket – it will hold/adhesive front lip to the bumper/brackets ! SAM_2594  SAM_2568

If the holes is not predrilled in the front lip – please drill it and right after install the front lip : upper part must match the brackets and lower part must be screwed/fastened to a bumper

SAM_2597 SAM_2569

Rear diffuser/lip and side flaps installation

  Required2) 3) 4) 5)

Do a test fit on both sides there are places for rivets/screws – drill it and install rivets ( install rivets only AFTER the lip is prepared for installation using adhesive)

Prepare the diffuser in accordance to method provided by adhesive manufacturer

SAM_2534

For a better fixation apply adhesive all around the inner perimeter

SAM_2537

Istall the diffuser and fasten in underneath the car using screws/bolts

SAM_2539

SAM_2542

“Ears” or side flaps –  must be installed using adhesive and existing bolts

SAM_2562

SAM_2532

Rear spoiler and mirror covers installation

  Required  2) 3) 4) 5)

Apply adhesive all around the inner perimeter, install the spoiler/mirror covers and fasten it with scotch tape for a 24h

Spoiler :

SAM_2561

Mirro covers :

SAM_2574

SAM_2577

ENJOY

SAM_2621

SAM_2623

Leave a Reply

Your email address will not be published. Required fields are marked *

Translate »