Installation manual for BMW X5 F15 Carbon Fiber M Performance

BMW X5 F15 ( non LCI )

Equipped with M Sport package ( can be found here )

Following installation manual describes how to install : M Performance Carbon fiber bodykit for F15/MSport

First of all – all test fits and etc must be done with a bolt UNSCREWED from the lower part of bumpers – otherwise you will see that items are “bent and my super skilled professional says that it’s important to install it”

All surfaces must be cleaned with cleanser/degreaser

Front lip installation :

Install brackets / supporting frame ( drill two holes in brackets – holes are not predrilled because every front bumper have a little different size and shape ) by unscrewing two bolts from each lower side of front bumper – fasten brackets using two existing bolts and screw it to bumper ( upper part  ) – see pictures 1-2

Install front lip – sand the lip and brackets, drill holes in front lip – that holes must line up to car’s holes. Apply adhesive on a perimeter of the front lip then install it on to prepared front bumper, fasten lower bolts and fasten&tighten the lip using scotch tape – see pictures 2-8

Diffuser installation :

Apply adhesive on a perimeter of the whole diffuser like it’s shown on pictures then install it on to prepared rear bumper, fasten lower bolts and fasten&tighten the diffuser using scotch tape – see pictures

Rear flaps installation :

Align flaps like you wish – mark the places to drill the holes – drill holes, install using bolts

Mirror caps installation :

Remove the protection tape and stick the cover to your mirror caps

Leave a Reply

Your email address will not be published. Required fields are marked *

Translate »